*  Created and then bonded pushrod fairings to the right elevator and right aileron.

*  Replaced hex head bolts with round head SST bolts for the step mounts.

*  Added Molex connectors to all wires entering the fuselage from the wings. These were added just inside the fuselage so the wings can be removed.

*  Removed right flap in anticipation of installing the new flap from Arion.

*  Both wing tips were warped unacceptably so, per advice from

*  Added fixtures for the cockpit center console.

*  Added the firewall with 3M fire calking between the fuselage and the stainless steel sheet. It was also added in all the mating surfaces of the firewall recess.

*  The engine mount was installed with new AN7-34 drilled bolts. These bolts are backed up with 1/4"  thick ultra wide washers.